Removing The Refrigerator Doors - Samsung RF28HM Series User Manual

60" (1525 mm) -RF28 60" (1525 mm) -RF28
54 1/4" (1380 mm) -RF25 54 1/4" (1380 mm) -RF25
CAUTION
When moving your refrigerator
To prevent fl oor damage, be sure the front
adjusting legs are in the up position (above the
fl oor).
Refer to 'Adjusting the doors' on page 14.
Flat-blade screw Flat-blade screw
driver(-) driver(-)
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the fl oor. This surface
should be strong enough to support a fully loaded
refrigerator. To protect the fi nish of the fl ooring, cut
a large section of the cardboard carton and place
it under the refrigerator where you are working.
When moving a refrigerator, you need to pull and
push it straight forwards or back. Do not wiggle it
from side to side.
DA68-02952A-01.indb 10 DA68-02952A-01.indb 10
Control Lever Control Lever
English - 10
ACCESSORIES AND
REQUIRED TOOLS
The following accessories are included with your
refrigerator:
Hex wrench
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips Flat-blade
screwdriver(+) screwdriver(-)
Allen wrench
Pliers
(3/16") (5 mm)
REMOVING THE
REFRIGERATOR DOORS
For some installations, you need to remove the
fridge doors and freezer drawer so you can
move the refrigerator to its fi nal location. Do not
remove the doors/drawers if you don't need
to. If you do not need to remove the refrigerator
doors or drawers, go to 'Adjusting the Level'
on page 14. If you need to remove the doors
and drawers. continue below. Before removing
the doors or drawers, make sure you read the
following warnings:
WARNING
Disconnect power to the refrigerator before
removing the door or drawer.
• Be careful not to drop, damage,
or scratch the doors/drawer while
removing them.
Fastener
Socket wrench
(13/32") (10mm)
2013. 12. 3. 2013. 12. 3. 8:50 8:50