Sony BDV-N9200W Operating Instructions Manual page 15

F Soft-touch buttons/indicators
N* (play)
x* (stop)
./> (previous/next)
VOL +/–
FUNCTION (page 28)
Selects the playback source.
* Touch and hold N on the main unit
for more than 2 seconds, the built-in
sound demonstration will be played
back on the system. If a USB device is
connected, the audio contents from
the USB device will be played back as
sound demonstration.
Touch x to stop the demonstration.
Note
During the demonstration, the volume
level may be higher than the volume
level you have set.
G
(USB) port (page 33)
Place your fingernail in the slot to
open the cover.
Indicators in the top panel display
Repeat play
Stereo sound
is received
(Radio only)
* High-bandwidth Digital Content Protection
** When you press DISPLAY, the stream information/decoding status is displayed when
the function is set to "TV". The stream information/decoding status may not appear
depending on the stream or item being decoded.
H
(remote control sensor)
I Z (open/close)
About soft-touch buttons/
indicators
The soft-touch button indicators flash
each time you turn on the main unit,
wait until the indicators stop flashing.
The buttons only function when the
indicators are lit.
Note
• These buttons work when you touch
them lightly. Do not press on them with
excessive force.
• If the button does not work, release the
button and wait for a few seconds. Then,
touch the button again with your finger
covering the button indicator.
Muting is on
The system's status
(radio frequency, etc.)**
BLUETOOTH power
is on
The HDMI (OUT) jack
is correctly
connected to an
HDCP* compliant
equipment with
HDMI input
15
GB