Advertisement
TCA-500 C
OMBO
R
P
EAR
ANEL
Front LED Light
Switched AC Outlet
Socket (rear panel)
*NOTE: Standard versions are wired for domestic use only. Export units are available on special
order. Export AC Power Input range is 170-240 VAC, 50-60 Hz with an 8A 250VAC fuse.
CAUTION: Voltages outside this range could damage the unit and cause a shock hazard.
Telonics TCA-500 Combo Amp
PB-009289 Rev _ PRELIMINARY
A
C
MP
ONTROL
(
)
CONTINUED
The Front LED Light switch is a three-position toggle switch which turns the
Front panel LED illumination system to one of the following conditions:
"Bright" "Off" or "Dim".
Switched 110-120VAC outlet, fused with a 2 amp 250VAC 5x20mm glass
Slow Blow fuse. Note: This outlet is a C14connector in the export version.
To allow the combo to be powered from a single AC cord, a
switched AC power socket is provided to power up the effects unit.
WARNING – Mains voltage is present on this connection – DO
NOT insert any device into this socket other than the IEC lead
provided – If any liquid is spilled on the combo in this area
UNDER NO CIRCUMSTANCES should the combo be used, and
the AC mains cord plug should be IMMEDIATELY disconnected
from the AC mains supply socket.
The output voltage from the Switched AC socket will be the same
as applied to the combo AC mains cord plug. Always check to be
certain that your effects processor voltage suits the supply voltage
applied to the TCA-500 Combo Amplifier.
Note; the power taken by the effects processor should not exceed
50 Watts.
F
, J
UNCTIONS
ACKS
, & I
:
NDICATORS
20
Advertisement
