Stanley GBCPRO Instruction Manual page 6

Charging golf Carts
WARNING: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: Make sure the golf cart power is turned OFF
before attempting charging procedures. Refer to the golf cart user manual.
1. Insert either the O-Ring or battery clamps into the unit' s charger connector, then plug the unit' s 120 volt power plug into a
functioning AC outlet. The digital display will show the following red circulating pattern that loops clockwise to indicate the
charger is properly plugged in:
Connect the O-Ring or battery clamps as described in the following steps (refer to the following examples of golf cart battery
configurations to locate switches and terminals).
2. Place the TOW/RUN switch in the TOW position before connecting to the battery post.
3. Connect POSITIVE (RED) clamp or O-Ring from battery charger to POSITIVE (POS, P, +) terminal of battery that is connected to
the solenoid.
4. Connect NEGATIVE (BLACK) clamp or O-Ring from battery charger to NEGATIVE (NEG, N, -) terminal of battery that is connected
to the solenoid.
Style A Electric Battery Configuration
CoNNECT ThE NEgaTiVE
(BlaCK) ClaMP or
o-riNg To hErE
Tow/ruN
swiTCh
CoNNECT ThE PosiTiVE
(rEd) ClaMP or o-riNg
To hErE
10
Style B Electric Battery Configuration
CoNNECT ThE PosiTiVE
(rEd) ClaMP or o-riNg
To hErE
Style C Electric Battery Configuration
CoNNECT ThE PosiTiVE
(rEd) ClaMP or o-riNg
To hErE
5. When the charger is properly connected to the battery, the unit will automatically detect the battery voltage (6V, 12V, 24V, 32V
or 48V) and the appropriate battery voltage indicator LED will light. The 3-character digital display will show "000" to indicate
the charger is in standby mode (described at the end of this section) and is ready to use.
Note
: The unit may take several seconds to detect the battery voltage and during this period, pressing any buttons will have no effect.
"000" displays before proceeding to the next step.
6. Press the battery type selector button until the desired battery type LED lights. A beep will sound for each press of the button.
Notes:
The default selection is "GEL" type battery. Selecting an incorrect battery type may adversely affect charging performance. Refer to the battery
manufacturer' s specifications for battery type.
Make this selection BEFORE proceeding to the next step, as battery type cannot be selected once
charging has begun.
Tow/ruN
swiTCh
CoNNECT ThE NEgaTiVE
(BlaCK) ClaMP or
o-riNg To hErE
CoNNECT ThE NEgaTiVE
Tow/ruN
(BlaCK) ClaMP or
swiTCh
o-riNg To hErE
000
11
Wait until the