Related Manuals for Lorell NTS 33554
Summary of Contents for Lorell NTS 33554
- Page 1 Ceramic Tower Heater with Motion Sensor & Remote Control 33554 Part# NTS INSTRUCTION MANUAL Please Read And Save These Instructions...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Please read these instructions carefully and keep for future reference. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surface. -
Page 3: Electrical Ratings
15. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. 16. CAUTION: Avoid the use of an extension cord because the extension cord may overheat and cause a fire. -
Page 4: Operation
This product is rated 12.5 amps (1500W) at 120V, 60 Hz. FEATURES A: Temperature Pilot Lamp B: Clock Pilot Lamp C: Clock 1 D: Clock 2 E: Digital Indicator Tip-Over Switch - Shuts heater off automatically if unit tips over, Heater will resume once heater is properly oriented. - Page 5 • Press the POWER button to cycle through the functions until none of them are on (HI, LOW, AUTO, FAN). When then unit is turned off the fan will continue to run for 30 seconds to cool down. Setting the Clock To set or adjust the time while the unit is either ON or OFF.
- Page 6 While the unit is On, press the MODE button until you see and the word ON flashing Use the▲ and ▼ arrows to set the hours. Press MODE button to set the minutes, use the ▲ and ▼ arrows. Press MODE to finalize . Setting the Unit to turn off (Program 1) After setting the unit to turn on, the and the word OFF will be flashing.
- Page 7 POWER/MODE Function Map Temp Setting Time On(1) Time Off(1) Time On(2) Time Off(2) Time Set Mode HIGH Power AUTO Mode Time On(1) Time Off(1) Time On(2) Time Off(2) Time Set Press the POWER/MODE to cyc le through the function list accordingly. unction Of Oscillation When the heater is on and under operation, press the OSC key o run the oscillating motor.
-
Page 8: Additional Features
Press the UP or DOWN key once to start the temperature value adjustment. The set temperature light will be flashing. Then, press the UP or DOWN key again to adjust to the desired temperature setting. RESET INSTRUCTIONS This heater is equippe d with an overheating cut-off switch w hich will shut the unit off if the internal heating components overheat. -
Page 9: Specifications
• Never immerse the heater in water. • Pack the heater in the original carto n and store it in a cool and dry place. SPECIFICATIONS Model No.: 33554 (NTS) Voltage: 120V, 60Hz Current: Maximum co ntinuous draw: 12.5 Amps. Output: 5200 BTUs Power: LOW = 900 W atts, HIGH = 1500 Watts...