Download Print this page

Lorell 33553 Instruction Manual

Motion sensor oscillating heater with digital control

Advertisement

Quick Links

Motion Sensor Oscillating Heater
with Digital Control
33553
Part# NFE20C
INSTRUCTION MANUAL
Please Read And Save These Instructions
1

Advertisement

loading

Summary of Contents for Lorell 33553

  • Page 1 Motion Sensor Oscillating Heater with Digital Control 33553 Part# NFE20C INSTRUCTION MANUAL Please Read And Save These Instructions...
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS Please read these instructions carefully and keep for future reference. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surface.
  • Page 3: Save These Important Instructions For Easy Reference

    16. CAUTION: Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No.14 AWG minimum size and rated not less than 1875 watts. 17.
  • Page 4 plants or combustible material. Plug the heater into a grounded 120V outlet. The buzzer sounds, the thermal pilot lamp lights and the “E” Digital Screen indicates room temperature. Press the POWER button repeatedly to the desired setting. The cycle is as follows: Hi –...
  • Page 5 The thermostat is in effect in modes: Hi, Lo, and Auto and will heat to the desired temperature setting. A Lit Thermometer shows the current temperature. Note: Press both ▲ and ▼ synchronously can shift the temperature ”C” and “F”. Programming the Unit for Automatic Run Time (Setting the Timer) In order to program the unit, the unit has to be on Hi, Lo, Auto, or Fan.
  • Page 6 program to be effective. A Lit shows that the program has been set. A Red means that the program is in effect. To check a program that’s been set, repeat the steps above to show the Flashing and it will show you the time that has been programmed. To cancel a program, cycle through the functions by pressing the POWER to turn off, turn on again if needed.
  • Page 7: Additional Features

    Never immerse the heater in water. • Pack the heater in the original carton and store it in a cool and dry place. SPECIFICATIONS Model No.: 33553 (NFE20C) Voltage: 120V, 60Hz Current: Maximum continuous draw: 12.5 Amps. Output: 5200 BTUs Power: LO =900 Watts...