Design Features - Rockford Fosgate Punch P200.2 Installation And Operation Manual

DESIGN FEATURES
Connections
10
P 2 C J C J . 2 P 2 5 C J . 2 P : 3 2 5 . 2 P 4 5 C J . 2
8 9
3
I
2
6 7
5
4
I. Power LED (Top of unit) -
This Blue LED illuminates when the unit is turned on.
2.
Thermal LED (Top of unit) -
This Red LED illuminates if the amplifier reaches the third stage of
thermal protection.The amplifier will shut down to cool if this occurs.
3. Protect LED (Top of unit) -
This Yellow LED illuminates if a short circuit or too low of an impedance
is detected at the speaker connections.The amplifier will automatically shut down if this occurs.
4.
Cast Aluminum Heatsink -
The cast aluminum heatsink of the Punch amplifier dissipates heat
generated by the amplifier's circuitry.
5. Speaker Terminals -
The heavy duty, nickel-plated clamp wire connectors (+ and -) will accept wire
sizes from 8 AWG to 18 AWG.
6. Remote Bass (All models except P200.2) -
Boosts low frequency information to overcome road
noise and put the
bass in your face.
The Remote Bass control is a narrow band adjustment at 45Hz
variable from OdB to + 18dB with a Gyrator based Punch EQ that eliminates frequency shift with boost.
Connection is made with a RJ-45 cable and can be installed in a variety of ways for easy control access. An
optional Para-Punch Remote Bass is available which adds an adjustable center frequency control with the
adjustable boost control.
7. Gain Control - The input gain control is preset to match the output of most source units. It can be
adjusted to match output levels from a variety of source units.
8.
Variable Crossover -
Is a built-in 12dB/octave Butterworth filter selectable for High-Pass (HP),AII Pass
(AP), or Low-Pass (LP) operation variable from 40Hz to 400Hz.
9. RCA Input Jacks -
The industry standard RCA jacks provide an easy connection for signal level input.
They are nickel-plated to resist the signal degradation caused by corrosion.
10.
RCA Pass-Thru Jacks -
The Pass-Thru provides a convenient source for daisy-chaining an additional
amplifier without running an extra set of RCA cables from the front of the vehicle to the rear amplifier
location.
4