Before Using Your Kenwood Appliance; Before Plugging In; Safety; Before Using For The First Time - Kenwood MG700 series User Manual

Use the meat grinder to process
meat, poultry and fish. Use the
inclusive attachments to shape
sausages and kebbe.
before using your Kenwood
appliance
Read these instructions carefully and
G
retain for future reference.
Remove all packaging and any
G
labels.

safety

Always ensure bones and rind etc
G
are removed from the meat before
mincing.
When mincing nuts only feed a few
G
down at a time and allow the scroll
to pick them up before adding any
more.
Always unplug:
G
before fitting or removing parts
G G
after use
G G
before cleaning.
G G
Always use the pusher supplied.
G
Never put your fingers or utensils in
the feed tube.
Warning - the cutting blade is sharp,
G
handle with care both in use and
cleaning.
Ensure the attachment is secured in
G
position before switching on.
To avoid electric shocks, never let
G
the power unit, cord or plug get wet.
Never use a damaged appliance.
G
Get it checked or repaired: see
'Service'.
Never use an unauthorised
G
attachment.
Never let the cord hang down where
G
a child could grab it.
This appliance is not intended for
G
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
English
Children should be supervised to
G
ensure that they do not play with the
appliance.
Only use the appliance for its
G
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.

before plugging in

Make sure your electricity supply is
G
the same as the one shown on the
underside of your machine.
important (UK) only
The wires in the cord are coloured
G
as follows:
Blue = Neutral
Brown = Live.
The appliance must be protected by
G
a 13A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse
G
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
G
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.

before using for the first time

1 Wash the parts see 'care and
cleaning'
2 Push excess cord into the cord
stowage compartment at the back
of the power unit.
4