Page 3
Features ticated compasses available for use in a • Patented magnetic sensor technology vehicle. The Wayfinder V2000 is one of sev- same as the built-in compasses in GM, eral models using our latest technology to Ford, and Chrysler vehicles. make a digital compass easy and fun to •...
Page 4
FEATURES • Automatic shut-off when no magnetic • Holographic LCD improves brightness field changes have been sensed for and contrast while removing glare. approximately 10 minutes. • One-year warranty. • Programmable automatic backlight shut- off feature. • Photo diode light sensing feature turns the backlight on or off depending on the amount of ambient light when used with 12-volt adapter.
Page 5
CONVENTIONS USED IN THIS MANUAL The manual is designed with procedures 4. “Press” means quickly press and release a organized in the order that they will be needed. button in less than two seconds. Additional information about procedures or 5. “Hold” means press and hold the button compass use can be found in our Frequently for at least two seconds, or until a display Asked Questions section.
DISPLAY “DISTORTION” Cardinal Point Numeric Heading Battery Photo Diode Icon Readout Readout Compartment Compass Rose Temperature and Buttons Temperature 12-Volt Power Bearing Point Readout Sensor Jack AdapterJack Compass Front Compass Back...
Page 8
Power button Buttons and icons Press to turn the Wayfinder V2000 on Light button or off. Press to turn the backlight on or off or “Distortion” icon hold to set the backlight auto shut-off value.
Step 1: Installing the battery reinsert the battery. Whenever the battery is The unit uses a 3-volt CR123A lithium-type changed or removed, the V2000 will need to battery, installed according to the diagram be recalibrated. on the inside of the battery compartment.
Wayfinder engine heat in a place where there is natural V2000 at all times to allow the unit to air flow to the sensor, such as in the grill keep memory settings.
Page 11
2. Before removing the backing tape from the adhesive surface, make sure the Do not leave the Wayfinder V2000 in mounting surface is free of oil and dirt. a parked vehicle that is likely to be...
Page 12
HEADER INSTALLING THE WAYFINDER V2000 Adjustment of this bracket does not require the use of a screwdriver. Please do not remove the screw from pivot point of the bracket,theinternal parts are small and can easily be lost.
Page 13
HEADER INSTALLING THE WAYFINDER V2000 Step 4: Mounting the Bracket is achieved and check that the teeth have 1. Install the suction cups into the mounting locked securely into place. bracket by sliding them into their holes 5. Slide the unit all the way into the compass (if not pre-installed).
Page 14
Dashboard • The accuracy of the Wayfinder V2000 will be diminished by a strong magnetic • Choose a place on the windshield that will field, such as that found in proximity to not obstruct the driver’s view and is easily...
4. Press seconds. “ ” displays briefly in lower right DONE 2. Press corner. The V2000 is now calibrated. At the same time, “ ” will TURN ONCE flash on and off in the lower left corner, and “ TURN ONCE THEN PRESS CAL TO...
BEARING POINT MODE Bearing point allows one numeric heading to 3. Press be stored and displayed for use as a reference The stored bearing point appears numer- point. If the battery was just installed, 00° ically in the lower right corner and as a displays in the lower right corner.
1. Hold Temperature display is turned on or off. The message “ PRESS AGAIN TO STEP HOLD ” cycles in the lower right corner. The Wayfinder V2000 displays temperature TO SELECT readings between 1°F and 158°F (-17°C to 2. Press 70°C).
ICE alert feature warns -17°C minimum. you if the temperature drops to 35°F (2°C). When this happens, the Wayfinder V2000 will Similarly, If the temperature rises above 158°F automatically switch to temperature mode (70°C), the display will flash “...
BACKLIGHT MODE Press to turn the backlight on or off. To 3. Hold program the backlight auto shut-off value, To select the interval for the auto shut-off do the following: until “ ” displays. DONE 1. Hold 4. Press “ ”...
BACKLIGHT MODE Photo diode feature The 12-volt adapter or optional hard- The Wayfinder V2000 comes equipped with wire kit must be installed for the photo a photo diode light sensor that turns the diode feature to work. backlight on or off depending on the amount of ambient light it senses.
OPTIONAL ACCESSORIES A hard-wire kit is available for an addi- A 30-foot temperature sensor tether is tional charge by calling our customer ser- available for an additional charge by vice department at (888) 422-6672 from calling our customer service depart- anywhere in the U.
Where can the Wayfinder V2000 be used? the earth’s field from your vehicle’s magnetic The Wayfinder V2000 can be used in any type field. The Wayfinder V2000’s microprocessor of vehicle including cars, trucks, vans, SUVs, electronically subtracts your vehicle’s magnetic...
Page 23
5 degrees. The compass V2000? rose shows a solid arrow pointing in the The Wayfinder V2000 needs to be calibrated direction you are heading. when used for the first time in a vehicle, What is calibration, and why is it necessary?
Page 24
Many things generate external magnetic fields battery has just been installed, and calibration causing compass inaccuracy, including metal is necessary. and electronics. The Wayfinder V2000 senses any significant change in magnetic fields. How can I improve the calibration process? “...
Page 25
FREQUENTLY ASKED QUESTIONS how you will be using the unit. For example, How can the bearing point feature help me? you should calibrate with the temperature Setting a bearing point to a desired heading or tether and 12-volt adapter attached to the to a sighted landmark allows you to monitor unit (if you intend to use the 12-volt and maintain your heading and remain on...
Proof-of-purchase must show printed PNI Corporation, please do the following: date of purchase, model number, and 1. Obtain a return merchandise authoriza- place of purchase. There will be a charge...
Page 27
Once you have acquired a RMA number, pack the unit securely to prevent damage PNI Corporation in transit. If possible, use the original 5464 Skylane Boulevard, Suite A packing material and box. Be sure to send Santa Rosa, CA 95403-1084 the entire product.
(ii) the period of time remaining on accident or unauthorized repair. the original one (1) year warranty. If the product is found by PNI to be defective THE FOREGOING WARRANTY IS GIVEN and you have provided proof of purchase IN LIEU OF AND PNI DISCLAIMS ALL acceptable to PNI, PNI’s entire liability and...
Page 29
PURPOSE, OR (2) THAT USE OF THE including, but not limited to, loss of use, PRODUCT WILL BE UNINTERRUPTED revenue or profit. In no event shall PNI’s total AND ERROR FREE. liability for all claims regarding the product exceed the price paid for the product. PNI...
Page 30
NOTES GENERAL SPECIFICATIONS • Battery life: 3,600 hours without backlight, 140 hours with constant backlight usage. • Operating temperature range (°F/°C): 14°F to 140°F / -10°C to 60°C • Storage temperature range (°F/°C): -40°F to 185°F / -40°C to 85°C •...
Need help?
Do you have a question about the Wayfinder V2000 and is the answer not in the manual?
Questions and answers