Abocom 802.11g Wireless Access Point WAP253 Quick Install Manual

802.11b/g Access Point
1 1
Check for Packing List:

Hardware Installation

Notes
Before you starting hardware connection, you are advised to
find a appropriate location to place the Access Point. Usually,
the best place for the Access Point is at the center of your
wireless network, with line of straight to all your wireless
stations. Also, remember to adjust the antenna; usually the
higher the antenna is placed, the better will be the
performance.
[ Wireless Access Point ]
Default IP address: 192.168.1.254
Power Adapter
SSID: 802.11g-AP
Channel: 11
DC 12V
Device name: Wireless AP
Encryption: Disabled
To Ethernet network equipment,
e.g. Router, Switch, or another
Wireless Access Point
Step 1. Connect to your local area network: connect a
Ethernet cable to one of the Ethernet port (LAN1 or
LAN2) of this Wireless Access Point, and the other end
to a hub, switch, router, or another wireless access point.
Step 2. Power on the device: connect the included AC power
adapter to the Wireless Access Point's power port and
the other end to a wall outlet.
Check the LEDs:
¨ The Power and LAN # LEDs should be ON. LAN# LED
will even blink if there is traffic.
¨ The Link/Act LED will blink if no client station is being
associated to this Wireless Access Point.
¨ If the ErrStatus LED glows, it means this Wireless
Access Point fails on self test. Please ask your dealer for
technical support.
Step 3. Configure your PC.
Make sure your local PC(s) has wireless network
adapter installed.
Check the LED:
¨ The Link/Act LED should be ON in static when your PC
associates to this Wireless Access Point.
[ PC_WLAN ]
IP address: 192.168.1.xx
ESSID: 802.11g-AP
Channel: 11
Encryption: Disabled
Ethernet
UTP cable

Quick Install Guide

In order to use the Access Point, other Wireless devices must
use the same SSID and WEP settings as the Wireless Access
Point.
The Wireless Access Point's default settings are as follows.
Wireless Access Point's default settings
2 2

Access Point Configuration

Wireless 1.Start your computer. Connect an Ethernet cable between your
LAN Card
computer and the Wireless Access Point.
2.Make sure your wired station is set to the same subnet as the
Wireless Access Point, i.e. 192.168.100.12.
3. Start your WEB browser. In the Address box, enter the
following:
No username and password required for the first login (default setting).
However, you can assign a set of username and password for
future security.
802.11g-AP
H T T P : / / 1 9 2 . 1 6 8 . 1 . 2 5 4
4
M73-APO07-590