Rear Panel - Inter-m EQ-2231A Operation Manual

Rear Panel

Rear Panel
1
1. AC CONNECTOR AND FUSE HOLDER
Connect the supplied standard AC input cable to this input. The fuse holder below the input contains the AC
overload protection fuse. If the fuse has blown out, replace it with a fuse of the same type and rating. If the
fuse continues to blow, refer servicing to a qualified service technician.
2. DC INPUT TERMINAL
This terminal is provided for the connection of 24V DC power source. Connect a 24V DC battery source to
this terminal.
3. BALANCED XLR INPUT CONNECTORS
One balanced 3-pin female XLR input connector is provided for channel. This connector is wired in Parallel
to the corresponding balanced Euroblock output connector.
4. BALANCED EUROBLOCK INPUT CONNECTORS
One balanced male Euroblock input connector is provided for channel. This connector is wired in Parallel to
the corresponding balanced XLR input connector.
5. BALANCED XLR OUTPUT CONNECTORS
One balanced 3-pin male XLR output connector is provided for channel. This connector is wired in Parallel to
the corresponding balanced Euroblock output connector.
6. BALANCED EUROBLOCK OUTPUT CONNECTORS
One balanced male Euroblock output connector is provided for channel. This connector is wired in Parallel
to the corresponding balanced XLR output connector.
7. GROUND LIFT SWITCH
This switch provides connection or disconnection of the equalizer ground to AC "earth" ground to prevent
noise from ground loops. Under most circumstances, this switch should be set to FRAME position.
2
DUAL 31- BAND GRAPHIC EQUALIZER
6
3 4 5
7
7
EQ-2231A