Troubleshooting - Toolshop SKU 208-2136 Operator's Manual

Troubleshooting

Caution: Stop using the tool immediately if any of the following problems
occur. Serious personal injury could occur.
Problem
Air leaking at
Trigger area
Air leaking
between body and
drive guide (48)
Air leaking
between body and
cylinder cap
Blade driving
fastener too
deeply
Runs slowly or has
power loss
Tool skip a
fasteners
Fasteners are jammed
Tool will not drive
down tight
Cause
1. O-ring in trigger valve is damaged.
2. Trigger valve head are damaged.
3. Trigger valve stem, seal or O-ring
are damaged.
Damaged piston O-ring or bumper
1. Screw loose.
2. Damaged seal.
1. Worn bumper.
2. Air pressure is too higher.
1. Insufficient oil.
2. Insufficient air supply.
3. Broken spring in cylinder cap.
4. Exhaust port in cylinder cap is
blocked.
1. Worn bumper or damaged spring
(51).
2. Dirt in drive guide (48).
3. Inadequate airflow to tool.
4. Worn or dry O-ring on piston.
5. Damaged O-ring on trigger valve.
6. Cylinder cap seal leaking.
1. Joint guide is worn.
2. Fasteners are wrong size or
damaged.
3. Magazine or front plate screws are
loose.
4. Blade in piston assembly is
damaged.
1. Worn blade in piston assembly.
2. Lack of power.
3. Slow cycling and loss of power.
Solution
1. Check and replace O-ring.
2. Check and replace trigger valve
head.
3. Check and replace trigger valve
stem, seal or O-ring.
Check and replace O-ring or bumper.
1. Tighten screws.
2. Check and replace seal.
1. Replace bumper.
2. Adjust the air pressure.
1. Lubricate as instructed.
2. Check air supply.
3. Replace spring.
4. Replace damaged internal parts.
1. Replace bumper or pusher spring.
2. Clean drive channel of front plate.
3. Check hose and compressor fittings.
4. Replace O-ring or lubricate.
5. Replace O-ring.
6. Replace seal.
1. Replace joint guide.
2. Use the recommended and
undamaged fasteners.
3. Tighten screws.
4. Replace piston assembly.
1. Replace piston assembly.
2. Adjust to adequate air pressure.
3. Check cylinder cap spring for
broken coils or reduced length. Check
if exhaust port of cylinder cap is
restricted.
11