Set Location; Any" S.a.m.e. Code Is Factory Default; Single" S.a.m.e. Code; Multiple" S.a.m.e. Codes - Midland WR120 Owner's Manual

WR-­120 Owner's Manual
Set Location:
Your WR-­120 All Hazards Weather Alert Radio comes preprogrammed to
receive weather and hazard alert transmissions for all S.A.M.E. codes within
range. If this is what you want, leave the radio set to ANY.
"Any" S.A.M.E. Code:
1. Press MENU to open menu options.
2. Press to scroll through menu to SET LOCATION, then press SELECT .
3. Press to ANY then press SELECT .
4. Press MENU to exit menu mode.
"Single" S.A.M.E. Code:
1. Press MENU to open menu options.
to scroll through menu to SET LOCATION, then press SELECT .
2. Press
to SINGLE then press SELECT .
3. Press
4. SAME 01 will be displayed. Press SELECT .
5. Use
6. Press SELECT .
7. Press MENU to exit menu mode.
Note: In the single mode the last S.A.M.E. code programmed will
be the only one the radio alerts to, even though multiple codes can
be entered in alternate S.A.M.E. positions.
"Multiple" S.A.M.E. Code:
1. Press MENU to open menu options.
to scroll through menu to SET LOCATION, then press SELECT .
2. Press
3. Press to MULTIPLE then press SELECT .
4. SAME 01 will be displayed. Press SELECT .
5. Use
6. Press SELECT .
7. Press to advance to SAME 02.
8. Repeat steps 4-­7 to program up to 25 codes.
9. Press SELECT .
10. Press MENU to exit menu mode.
Note: While in MENU mode, if no buttons are pressed for
60 seconds, the radio will automatically exit MENU mode.
page 7
(recommended)
or to program the 6 digit S.A.M.E. code.
or to program the 6 digit S.A.M.E. code.
www.midlandradio.com