Specifications - Kitsound Clock Dock User Manual

Manual channel memory
When get acess to the channels by manual, press "
choose the saving location. 20 channles can be memorized and saved.
Memory selection:
Press " /MEM/SET"to alternate the memory channel.
3. AUX operation
Select AUX under power on and input the external music source to AUX, turn on volume and the music is ready.
Volume:
VOL- and VOL+ can be adjusted within 00-20.
Clock setting:
Under standby mode, press "
" /T- "or " /T+" to set "hour" and tap "
confirm the setting and resume to clock mode.
Alarm setting
Under STAND BY mode, press and hold "VOL-/AL MODE" when there will be time displaying and LCD shinning. Tap
" /T- " or " /T+" to set "hour" and"VOL-/AL MODE"to set "mimute" and then tap"VOL-/AL MODE" again to
confirm the setting and return to clock mode.
Alarm mode setting:
Tap " /T- " or " /T+" and enter into the alarm setting mode TONE/IPOD/RADIO
"VOL-/AL MODE" to return to clock mode.
SNOOZE:
When Alarm rings, press "SNOOZE" to set up snooze function. Then alarm pauses and will ring again in 9 minutes, if press
"POWER" at this time, the alarm will stop and terminate.
SLEEP:
Press "SNOOZE/SLEEP/LIGHT" under any mode and then start to set the snooze and select
120M-90M-60M-30M-15M-OFF.
LIGHT:
There are three brightness modes of LCD when the unit is in stand-by.

Specifications:

Power supply
Tuning system FM
Tuning sensitivity
Frequency response
S/N Ratio
Audio output
Audio input
Specifcations and instructions manual are subject to change without notice.
/MEM/SET"and hold for a while. Press "
/MEM/SET" and hold it into clock setting, then there will be clock shining on LCD. Tap
/MEM/SET" to set "minute", then press"
DC 5V
AC 100 - 240 V adapter
87.5 - 108 MHz
FM < 20 dB
20 Hz - 20 kHz (aux in)
> 60 dB
Stereo speaker (1.2 W x 2)
iPod dock
3.5 mm auxiliary line in
/T- "or " /T+" to
/MEM/SET"again to
Select the mode and tap