EnGenius ECB9500 Datasheet page 7

ECB-9500 7 Functions
>
ECB9500 Datasheet Version 01222009
*Theoretical wireless signal rate based on IEEE standard of 802.11 a, b, g, n chipset used. Actual throughput may vary.Network conditions and environmental
factors lower actual throughput rate.
** All specifications are subject to change without notice
Learn more about EnGenius Solutions at www.engeniustech.com.sg
Datasheet
ECB9500
01.AP MODE
The most basic mode of multi-function Access Point. In this mode,
the AP will act as a central hub for different Wireless LAN clients.
Some hotsports APs requires 802.1x authenticator function to
authenticate a user before providing internet service.
02.CLIENT MODE
Also known as Ethernet Client. In this mode, AP will act as a
WLAN card to connect with remote AP. Users can connect PC or
local LAN to the Ethernet port of the client mode AP. This mode is
mostly used as a CPE device for WISP subscriber service.
03.ROUTER MODE
The LAN port will behave as a WAN port for wired connection to
ADSL or Cable modem. The NAT routing will be performed
between the WAN and LAN port. Making IP sharing possible.
04.BRIDGE MODE
In This mode, 2 access points is being connected to provide a
wireless bridge between 2 remote LANs. It is mostly used by
enterprise to connect 2 remote office's network together. The
bridge mode is connected by using either the WDS (Wireless
Distributed System) or ADHOC topology.
BUSINESS CLASS
ECB9500