Removing And Installing The Door Panels - Bosch HBA63S4.1A Instruction Manual

Attaching the door
Reattach the oven door in the reverse sequence to removal.
When attaching the oven door, ensure that both hinges are
1.
inserted straight into the opening (figure A).
The notch on the hinge must engage on both sides (figure B).
2.
$
Fold back both locking levers (figure C). Close the oven
3.
door.
&
ã=
Risk of injury!
Risk of injury. If the oven door falls out accidentally or a hinge
snaps shut, do not reach into the hinge. Call the after­sales
service.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
Detach the oven door and lay on a cloth with the handle
1.
facing down (figure A).
First undo the two bottom screws and then the two top
2.
screws (figure B).
$
Remove the complete door base (figure C).
3.
&
14
%
%
Remove the two clips from the top of the panel (figure D). To
4.
do this, push the clip downwards slightly with your thumb and
pull the tab outwards with your index finger (figure E).
'
Lift the inner panel, push it slightly upwards and then pull it
5.
down and out (figure F).
)
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. The
glass could be damaged.
Installation
During installation, make sure that the lettering "right above" is
at the top right.
Insert the inner panel diagonally upwards and attach at the
1.
bottom (figure A).
$
Reinsert the clips on the top left and right (figure B). To do
2.
this, hook the clips into the top of the bracket and press firmly
until they engage (figure C).
%
(
&