Showing Of Bob2 - Westnet BoB2 User Manual

Showing off BoB2
TM
BoB2 is sleek and stylish so we don't blame you for wanting to
TM
show him off. There are a few different ways to display BoB2
the BoB2
handset.
TM
connected to BoB2 handset and
1. BoB2 TM TM
standing up right using the supplied stand in the
modem box.
2. Showing off BoB2 on his own and the handset
TM
stood upright with its own stand that was
supplied in the handset box.
3. BoB2 and the BoB2 handset stand together.
TM TM
Things are better when we're together
The easiest way to set up the modem and handset
in this configuration is to first follow the steps in the
quick install guide and get online. Then you can turn
off BoB2 and follow these steps to attach the stand,
TM
keep all the cables you are using in a convenient
place as you will need these in the steps detailed on
the next page.
22 Showing off
and
TM To display BoB2 TM and the handset as one unit, they first need to be attached to each other. The handset will then get
its charge from the BoB2 TM USB port on the left hand side. This USB port is a dedicated charge port and not used
for anything other than charging the handset. You will not need the power adapter that came with your handset so
keep this in a safe place.
1. Lay the modem and the handset charger face down (on a protective cloth - to prevent scratches). Slide out the
upper and lower connection points on the back left hand side of the charger, this will expose the USB charger
point and location pins (figure 1).
2. Leaving the handset charger and BoB2 facing down, slide them together so you can locate the handset USB
TM
charger into BoB2 as shown below (you may notice lower slider does not move all the way across – this is normal)
TM
(figure 2).
3. Now take the large stand that was supplied in the modem box and pass the cables in the format below. The
example below shows the power cable, the ADSL phone cable and an ethernet LAN cable (figure 3).
4. Next align the stand over the top of the handset and BoB2
5. Make sure all the pins on the stand are sitting inside the holes on the handset and BoB2
amount of downward pressure, whilst at the same time push the stand upward toward the top edge of the
modem. You will hear a small click as the pins interlock (figure 5).
TM (figure 4).
and apply a small
TM
Showing off 23