Controlling From An Ir Remote Control - neo things Avalon User Manual

Once one of the three In/Audio/Video buttons have been pressed,
the Avalon matrix switch will light the inputs that are available for
selection, 1 to 6 for 6x2 models, and 1 to 8 for 8x4 models. The 0
button will also be lit. Selecting 0 as the input number will mute
whatever output is selected in the following steps.
After an input number has been selected, press the "Out" key.
And finally, after pressing "Out", press the Output number 1 to 2
or 1 to 4 you wish to route the signal to.
To recap, the front panel is always done as a four-button sequence
of (In/Audio/Video), (number), (Out), (number).
Some typical examples of this might be the following.
Example 1 - You would like to route your Cable box on Input 5 to
your main display on output 1. Press In, 5, Out, 1.
Example 2 – You wish to now route your audio from your CD
changer on input 3 to the main AV receiver on output 1, but
continue watching the cable box from example 1. Press Audio, 3,
Out, 1.

Controlling from an IR remote control

The command sequence for controlling the Avalon matrix switch
from an IR remote control is exactly the same as controlling the
switch from the front panel. If you have skipped ahead to this
section, please go back and read the section "Controlling from the
front panel" first.
If you have purchased the optional Neothings remote control, you
will notice there are more buttons than are required to operate the
Avalon matrix switch. These are for future use and are not used on
this product.
Programmable remote controls can be supported by teaching the
programmable remote the IR commands directly from the
11
Avalon Matrix Switch User's Guide (document number 42-00001-A)