Level Diagram - Kenwood TK-760HG Service Manual

Receiver Section
Center Frequency
Transmitter Section
Control Unit
To make measurements in the AF section, connect the AC level meter.
AG is set so that MIC input becomes 3kHz/1.5kHz (Wide/Narrow) DEV at 1kHz MOD.
52
TK-760HG/762HG

LEVEL DIAGRAM

49.95MHz
To make measurements in the RF section, connect the RF
level meter.
In the RF section, use a 0.01µF coupling capacitor.
(The display shows the SSG input value required to obtain
12dB SINAD.)
TX-RX Unit VCO Unit
To make measurements in
the RF section, connect the
RF wattmeter (50Ω).
TK-760HG/762HG
450kHz
To make measurements in the AF section, connect the AC level meter.
(ANT input : –53dBm, 1kHz FM, 3kHz DEV (Wide) / 1.5kHz DEV (Narrow))
The AF output level is adjusted for 0.45V/4Ω by the front panel AF VOL control.
TX-RX Unit
53
Audio Frequency
Power Module TX-RX Unit