Sharp SoftBank 203SH User Manual page 129

Washing Handset
Wipe off dirt, sand, beverage, etc., gently with a cloth. Then
hold handset approximately 10 cm below faucet or shower
head and wash with low-pressure tap water (6 liters/min. or
lower) at normal temperature (5
hands, taking care not to open Port Cover; do not use a brush
or sponge. Dry handset before use; after drying it well, install
Battery Cover then power on.
・Before washing handset, make sure that Card Slot Cover and
Port Cover are closed firmly.
・Do not use a washing machine or ultrasonic cleaner.
・Headphone Port tends to accumulate dust, sand, etc.; rinse
it off and dry Headphone Port completely before use. Any
residue may cause malfunction.
・Do not put a cotton swab, cloth, etc. into Headphone Port;
water/dust resistance may be affected causing malfunction.
・Do not place handset in a microwave oven to dry it. Internal
Battery/handset may leak, burst, overheat or ignite; may
cause malfunction, accident or injury.
・Do not dry handset using extreme heat (hot air from dryers
or other sources); may cause warping, discoloration or
damage.
C - 35 C). Wash with your
o o
Drying Handset
Dry Headphone Port, Earpiece, Mic and Speaker when exposed
to water.
Wipe handset surface with dry cloth
Remove Battery Cover (see here
Holding handset firmly by its sides, shake it about 20 times
Pat against dry cloth to remove moisture from grooves
・Do not put a cotton swab, cloth, etc. into openings.
Leave handset on dry cloth for approximately 2 - 3 hours at
room temperature
Replace Battery Cover (see here
Important
Do not use wet handset.
・Voice quality may be affected, or moisture may transfer
to clothes, bag, etc.
・Moisture may short-circuit Headphone Port or other
parts.
・Exposure to cold may freeze moisture; may cause
malfunction.
127
)
)