Summary of Contents for Cross Technologies 1583-10
Page 1
ALARM DUAL 1 : 4 RS-423 Data, drawings, and other material contained herein are proprietary to Cross Technologies, Inc., but may be reproduced or duplicated without the prior permission of Cross Technologies, Inc. for purposes of operating the equipment. When ordering parts from Cross Technologies, Inc., be sure to include the equipment model number, equipment serial number, and a description of the part.
WARRANTY - The following warranty applies to all Cross Technologies, Inc. products. All Cross Technologies, Inc. products are warranted against defective materials and workmanship for a period of one year after shipment to customer. Cross Technologies, Inc.’s obligation under this warranty is limited to repairing or, at Cross Technologies, Inc.’s option, replacing parts, subassemblies, or entire assemblies.
MODEL 1583-10 Data Distribution Amplifier 1.0 Equipment Description* The 1583-10 Data Distribution Amplifier is a dual-functionality unit which may be configured in either of two (2) modes: • 1:8 Mode, 1:8 data distribution plus pass-through mode; provides one (1) data input (J1) with eight (8) data outputs (J4 - J11) and a Input ‘pass-through’...
This switch has no affect if the selected also set with this switch. mode is 1:8. FIGURE 2.1 1583-10 REAR PANEL TABLE 2.0 INPUT / OUTPUT CONNECTORS Data Input: J1, J2, - Data Connectors (Figure 2.1) Data Output: J4, J5, J6,J7, J8, J9, J10, J11 - Data Connectors (Figure 2.1)
Page 5
Mode Status 2:4, Normally Open Mode Status 2:4, Normally Closed Mode Status 2:4, Common 1, 2, 3, 4 For Test Purposes Only, DO NOT CONNECT 5, 18 Ground 14, 15, 16, 17 Not Used 1583-10 Manual, Rev. A Page 5 06/10/10...
Illuminates red when no data activity is detected from DATA IN B (J2) for a time period of 1 minute and the selected mode is 2:4. Other time periods can be programmed at the factory by contacting Cross Technologies. (info@crosstechnologies.com) MODE 1:8 Illuminates green when the selected mode is 1:8.
2.3 Installation/Operation 1. Install the 1583-10 in the equipment rack. Rack-Mounting - To mount this equipment in a rack, please refer to the installation instructions located in the user manual furnished by the manufacturer of your equipment rack. Mechanical Loading - Mounting of equipment in a rack should be such that a hazardous condition does not exist due to uneven weight distribution.
Page 8
AC Fuse - 2 amp slow blow (Type T), 5 mm X 20 mm FUSE INPUT 100-240± 10%VAC TYPE T 2A GDC 47-63 Hz 250 VOLT 2A MAX FOR 100 - 240 V~ 1583-10 Manual, Rev. A Page 8 06/10/10...
Need help?
Do you have a question about the 1583-10 and is the answer not in the manual?
Questions and answers