Table of Contents
Advertisement
(VINYL, LINOLEUM, ASPHALT TILE AND NO WAX
FLOOR)
I . S C R U B B I N G ( F L O O R S R I P P I N G A N D
C L E A N T N G ) D T S C O N N E C T
C O R D F R O M
ELECTRICAL
OUTLET DO NOT USE MACHINE
TO SCRUB WOOD FLOORS.
Attach scrubbing brushes (for scrubbing ftoors
with an irregular surface) or nyton scrubbing
pads (for scrubbing ftoors with a smooth
surface).
Remove-dispenser
tank and fitt with , a stripper
and cteaner, dituted as indicated on container.
It is recommended to put the water in first to
avoid foaming.
Do not overfitt tank. Attow at [east one inch
air space to avoid spilting.
Attach dispenser.
Pl.ug cord into electrica[ outtet.
L o w e r h a n d l e i n t o o p e r a t i n g p o s i t i o n .
Turn switch to proper speed as indicated on
the switch box Labet.
C t e a n f t o o r u s i n g s m a t I c i r c u t a r s t r o k e s ,
dispensing [iquid as needed.
Do not dispense liquid ctose to the baseboards
to avoid sptashing watts.
W i p e u p s u d s w i t h a s p o n g e o f c t o t h .
Disconnect apptiance. Remove and wash pads
and brushes.
II. RENEWING
THE FINISH
To renew the finish of your just cleaned floors,
y o u m a y u s e a p r o t e c t i v e f t o o r f i n i s h .
III. PERIODIC
MAINTENANCE
S w e e p o r v a c u u m f t o o r f r e q u e n t L y .
Damp mop weekty.
NOTE: NYLoN PADS (#53871) AND BUFFING PADS
(#53471) NOT TNCLUDED
REFERIO PAGE 12, TO ORDER
OPERAT!ON
INSTRUCTIONS
Be sure to consutt floor manufacturer for proper
matntenance.
Never use water-based products on wood ftoors.
Onty use solvent based product on wood ftoors.
I. CLEANING
FotLow instructions on wood fLoor cleaner found
on sears Wood Ftoor Care Kit, or similar product.
II. WAXING
Foltow instructions on wood ftoor wax found
on Sears Wood Floor Care Kit, or simitar product.
I I I . P O L I S H I N G
DISCONNECT
CORD FROM ELECTRICAL
OUTLET.
Attach the tan potishing pads.
M a k e s u r e w a x i s d r y b e f o r e p o l i s h i n g .
Ptug cord into etectricaI outtet.
Lower handte into operating position. Turn
apptiance on.
GuÍde unit forward and backwards strokes,
fottowing the direction of the grajn unti[ the
desired finish is achieved.
Do not appty pressure, the weight of the
machine is sufficient.
Disconnect apptiance, remove and wash pads.
IV. BUFFING
DISCONNECT
CORD FROM ELECTRICAL
OUTLET.
Attach the fett buffing pads* or the [ambs wool
high tuster pads.
Ptug cord into etectricaI outtet. Lower hand[e
into operating position. Buffing witt leave your
ftoors truty Iustrous.
Disconnect appLiance, remove and wash pads.
Advertisement
Table of Contents
