Sears 680.84973 Owner's Mahual page 4

D O N O T P L U G I N E L E C T R I C C O R D U N T I L
BRUSHES OR OTHER ACCESORIES
HAVE BEEN
ATTACHED AND SWITCH HAS BEEN PLACED
IN THE "OFF" POSITION.
HANDLE,
SWITCH BOX AND CORD
1. Place tower handte tube (Fig. 1) into handte
tube socket "A" (Fiq. 2). Fasten using bolt "8"
and internalty threaded nut "C" (Fig. 3) provided
in the hardware package.
lf the handle tube is difficutt to assemble
(tight), insert blade of screwdriver into stot
(Fig. 4) at rear of handte tube socket and twist
screwdriver gentty white inserting handte tube.
2. Ptace upper hatf handLe tube (Fig. 1) over
tower hatf. Align hoLes and fasten with remajnjng
b o t t " B " a n d i n t e r n a l t y t h r e a d e d n u t " C " .
3. Attach switch box to rear of upper handte
tube. Place switch box tab (no hote) into
rectangutar hote (Fig. 5). Position box against
handte tube. Fasten using the smatt screw
provided in the hardware package. DO NOT
OVERTIGHTEN.
4. The motor cord, which goes from the switch
box to the bottom of the unit, is attached in
two (2) tocations behind the dispenser at top
and bottom. The upper part of the motor cord
is snapped into ptace alongside the upper cord
hook on the dispenser top (Fig 6).
The lower part of the motor cord is snapped
into ptace between the two tower cord hooks.
They are located on the dispenser base (Fig. 7).
5. Attach lower ptastic hose to rear of unit by
jnserting the fitting on the end of hose into
the hote located midway at rear of unjt (Fig. 8).
6. The etectric cord is wound around cord hook
as ittustrated in (Fig. 9).
Note: AtL moving parts requjring Lubrication
h a v e b e e n p e r m a n e n t t y t u b r i c a t e d a t t h e
factory.
ñs
llli
/i r
. ] ] U P P E R
L' HANDLE
T U B E
F I G . 2
a^
&¡a
F I G . 3
l ) 4
F I G . 6
,/h=
LJ€TJ]
FIG. 7
ASSH$dqmLY
INSTRUCTIONS
LOWER
HANDLE
T U B E
FtG. f