H20 Distributors USRO4-60-QC Installation And Service Manual

Reverse osmosis system with quick-connect fittings
Hide thumbs Also See for USRO4-60-QC:

Advertisement

Installation and Service Guide
Reverse Osmosis System with Quick-Connect Fittings
Please read this manual carefully
before attempting installation

Advertisement

Table of Contents
loading

Summary of Contents for H20 Distributors USRO4-60-QC

  • Page 1 Installation and Service Guide Reverse Osmosis System with Quick-Connect Fittings Please read this manual carefully before attempting installation...
  • Page 2 SyStem and Faucet dIaGram QUICK-CONNECT FITTINgS — HOw TO MaKE a CONNECTION Connecting standard quick-connect fittings Push up to pipe stop. Push the pipe into the fitting, to the pipe stop. The collet (gripper) has stainless steel teeth which hold the pipe firmly in position while the ‘O’ Ring provides a permanent leak proof seal.
  • Page 3 Your Reverse Osmosis (RO) System has been tested and gently push in the tubing until it will not go any further. to ensure it will operate correctly. The following periodic To ensure that your tubing has made a snug fit, pull back maintenance is recommended so your system will provide gently on the tubing;...
  • Page 4: Unit Preparation

    Procedures: A Drain Saddle is used to make a waste water connection 1. Mark the center with center punch for the 1/4” pilot with your drain under the sink. This is designed to fit hole. around a standard 1-1/2” OD drainpipe. The drain saddle 2.
  • Page 5 3. Self Piercing Valve and Tubing Installation 4. Drain Saddle Valve Installation (See Figure 3) The self-piercing valve, which is supplied, is designed for use with 3/8” to 1/2” OD copper or chrome plated A Drain Saddle is used to make a wastewater connection copper tubing, CPVC, &...
  • Page 6: System Start-Up

    cabinet sidewall, depending on where supply tank is to be tank has a full supply of water. located. Generally the unit is installed at the front of the cabinet and the tank at the rear. Icemaker lines are often run in the rafters of unfinished basements or finished basements with drop ceilings and To mount the unit, elevate it at least 2”...
  • Page 7: Membrane Replacement

    housing. of better quality with high pressure. The vast majority of 5. Discard old filters. problems with RO Systems are a result of low pressure. 6. Clean filter housings with a cleaning brush The effects of low pressure include water constantly 7.
  • Page 8: Pressure Temperature Chart

    PRESSURE TEMPERaTURE CHaRT Temp °F 0.2321 0.2653 0.2985 0.3316 0.3648 0.3979 0.4311 0.4643 0.4974 0.5306 0.5638 0.5969 0.6301 0.6632 0.6964 0.7296 0.2417 0.2762 0.3108 0.3453 0.3798 0.4144 0.4489 0.4834 0.5179 0.5525 0.5870 0.6215 0.6561 0.6906 0.7251 0.7597 0.2513 0.2872 0.3231 0.3590 0.3949 0.4308...

This manual is also suitable for:

Usro4-60-qc-38Usro5-60-qcUsro5-60-qc-38

Table of Contents