Invacare Tracer SX5 Owner's Operator And Maintenance Manual page 38

SECTION 6—SEAT AND BACK
5. Assemble the two new crossbraces together with the existing hex screw, coved washers,
washers and locknut. Securely tighten. Refer to Detail ʺBʺ for hardware orientation.
6. Determine the correct pivot link and mounting hole to use with the desired seat width.
See chart below.
7. Secure the pivot links to the crossbraces and wheelchair frame with the four button
screws and locknuts. Securely tighten.
NOTE: Position crossbrace saddle on wheelchair frame using the washer on the underside of the
wheelchair frame as a reference. See Detail ʺAʺ for proper positioning of the crossbrace saddle.
8. Reinstall the two button screws, locknuts and crossbrace saddle that secures the
bottom of the new crossbrace to the wheelchair frame. Refer to Detail ʺBʺ for hardware
orientation. Repeat for opposite crossbrace. Securely tighten.
9. Install the new back and seat upholstery onto the wheelchair. Refer to Replacing Back
Upholstery on page 36 and Replacing Seat Upholstery on page 36.
SEAT WIDTH
®
Tracer SX5
14 - INCH
18 - INCH
16 - INCH
I
18 - INCH
20- INCH
22 - INCH
FIGURE 6.5 Adjusting the Seat Width
PIVOT LINK
14 inch
X X
DO NOT USE
18 inch
16 inch
DO NOT USE
20 inch
22 inch
38
X
Part No. 1110550