Table of Contents
Advertisement
Installation Instruction
Installation Instruction
External Equipment Connections
External Equipment Connections
- To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
- Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides of the
screen may remain visible on the screen.
When connecting with an antenna cable
TV Back panel
VIDEO
(MONO)
L
AUDIO
R
Antenna
AV1
AV2
AV3
When connecting with a Scart cable
1
AUDIO/
(R) AUDIO (L)
VIDEO
VCR
• If your VCR outputs an AV switching signal via the AV1 or AV2 scart sockets, the set will switch to AV1 input source automati-
cally. But if you want to keep on watching TV mode, press the PR
• You can also record programmes received by the TV on video tape.
• The signal type RGB (the signals red, green and blue) can only be selected for the AV1 scart socket and the AV1 input source
can be received. These signals are transmitted, for example, by a pay TV decoder, game machine or photo CD unit, etc and that
digital signal can be recorded via AV1 scart socket.
• If the AV1, AV2 scart sockets have been connected to the VCRs simultaneously, only the AV2 input source can be received.
• In AV2 scart socket, the video output is not available.
12
VCR Setup
2
ANT IN
ANT OUT
S-VIDEO
OUT
(R) AUD
1
IN
VCR
TV Back panel
Antenna
AV1
AV2
Connect the ANT OUT socket of the VCR to the
1
Antenna socket on the set.
Connect the antenna cable to the ANT IN socket
2
of the VCR.
Press the PLAY button on the VCR and match the
3
appropriate programme between the TV and VCR
for viewing.
Connect the scart socket of the VCR to the AV1 scart
1
socket on the set. Please use shielded scart cable.
Insert a video tape into the VCR and press PLAY on
2
the VCR. (Refer to the VCR owner's manual.)
Select
A V1
input source with using the INPUT button
3
on the remote control.
- If connected to AV2 scart socket, select
source.
D D / E E
or number buttons.
input
A V2
Advertisement
Table of Contents
