System Settings - scope MPA3 User Manual

System Settings.

Test Call Message (Up to 18 Hours Timer, Up to 51 Chars)(1) Reset Message (Up to 21 chars).
Low Power Message (Up to51 chars) (2) Power Shut down Message (Up to 51 chars) (3)
Motion Sensor Trip Message(Up to 51 chars) (If fitted)
Contact Response Time = 10mS Min, 50mS Max
Read switch
Reed Switch Message to Cancel Ongoing Sensor Messages (Up to 22 Chars)
Can be used to turn the Accelerometer On/Off when not used.
Dimensions. (Including Case)
Length = 60mm Width = 43mm Height =25mm
1: Not recommended For Low power Battery Applications.
2: When a Low Power event is detected, the transmitter output power is automatically reduced in order to maintain
maximise battery life.
3: When the power can no longer support the Transmitter A power shut down message is transmitted.
R&TTE directive 1999/5/EC
EMC Directive (89/336/EEC) EN 301 489-1 V1.4.1
Low Voltage Directive (73/23/EEC) EN60950 : 2000
ETSI EN 300 220-1 V2.1.1 (2006-04)
ROHS II Compliant
Copies of the Declaration of Conformity covering this product can be obtained from Scope
FCC CFR 47 PART 90.213
Scope's policy is one of continuous development and specifications are subject to change without notice
MPA3
Compliance.
FCC ID: JRNUSAPENLINK
Page 10 of 11 Issue 1