Summary of Contents for scope MPA3
- Page 1 MPA3 Mobile Personal Alarm MK3 User Manual Scope Communications UK Ltd, Quantum House, Totnes, Devon TQ9 5AL United Kingdom Tel: +44(0)1803 860700 Fax: +44(0)1803 863716 www.scope-uk.com MPA3 Page 1 of 11 Issue 1...
-
Page 2: Important Installation Information
Removal of covers from the equipment must only be undertaken by authorised service personnel who must ensure that the unit is correctly sealed afterwards. Failure to do so could undermine the units water resistance performance. MPA3 Page 2 of 11 Issue 1... -
Page 3: Equipment Testing
It is therefore essential that equipment is inspected and tested by authorized service centres at least once a year. Literature Scope Communications UK Ltd, the manufacturer, in conjunction with its distributors operates a policy of continual improvement, and therefore reserve the right to modify or change any specifications without prior notice. -
Page 4: Warranty
The Lithium battery in this product is NOT rechargeable! Only replace batteries with the correct type and do not attempt to recharge. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. © Scope Communications UK Ltd, 2012 All Rights Reserved MPA3 Page 4 of 11... - Page 5 Accelerometer (if configured) and turns it back on when removed from the device. These units can be purchased separately if required, they are not required for the MPA3 to operate as the device can be configured to the user requirements in the factory.
-
Page 6: Operation
Necklace Button An internal button is connected to the MPA3 neck cord. When this cord is pulled from its socket the device will transmit a message to indicate that the cord has been disconnected. This message is continuously transmitted at configured intervals until the cord is placed back correctly into it's socket. - Page 7 Pendants can be factory configured to customer requirements. If the MPA3 configuration needs to be read (generally only a factory function), the MPA3 can be supplied with a USB "Read" cable which, when used in conjunction with the application software, can be used to read the MPA configuration data.
-
Page 8: Programming Software Installation
Please note FTDI drivers are continuously being updated. Your PC may already contain drivers for FTDI Devices. Scope application software has been tested with the drivers allocated on the software package disk and selected previous driver releases. The driver test list is shown above. MPA3 Page 8 of 11 Issue 1... -
Page 9: Specifications
Normally Closed Internal Contact connected to the Neck Cord. If the Neck Cord is broken then the unit will transmit repeatedly at the configured repeat time until the Neck Cord contact is repaired. Repeat Time can be configured (5 - 255 Seconds in 5 second steps) MPA3 Page 9 of 11 Issue 1... -
Page 10: System Settings
Copies of the Declaration of Conformity covering this product can be obtained from Scope FCC CFR 47 PART 90.213 FCC ID: JRNUSAPENLINK Scope’s policy is one of continuous development and specifications are subject to change without notice MPA3 Page 10 of 11 Issue 1... - Page 11 (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Scope’s policy is one of continuous development and specifications are subject to change without notice MPA3 Page 11 of 11 Issue 1...