Searching; Band Search; Limit Search - Uniden UBC180XLT Operating Manual

Band Search

The UBC180XLT has 14 Preprogrammed Search Bands.
You can search any of these Bands to find desired
frequencies if you do not have a Frequency Directory
handy, or if new stations have been added since the
Directory was published.
1.
Press and hold
Mode. Then the upper and lower limits of the band
currently selected are displayed.
2.
Use VFO control,
wish to search.
3.
Wait for about 2 seconds and the UBC180XLT will begin
searching that Band. Or, press
begin.
4.
During a Search, press
TURBO SEARCH. This increases the Search Speed to
300 steps per second in those bands that have 5 kHz
steps. (See the table on page for the Band Chart.)
When you activate TURBO SEARCH, the SEARCH
indicator flashes. Press
deactivate TURBO SEARCH.
5. Press
frequency. Press
6. When Search is stopped, you can press
to move up or down 1 frequency step. (See the table on
page for the step size for each Band.)

Limit Search

In Limit Search mode, you can search within the frequency
range you have set.
To use this function, you must set the lower/higher
frequency of your search range first.
Setting the Frequencies
1.
Press
2.
Enter the lower limit of your search range.
3.
Press

Searching

/ BAND to enter the Band Search
or
at any time to stop the search on a
/ BAND to resume searching.
.
.
to select the band you
/BAND again to
/ TURBO to activate
/ TURBO again to
21
or