Lift-Off Door - GE JBP22 Use And Care & Installation Manual

Lift-Off Oven Door
oven door is removable,
The
but it is heavy. You may need
help removing and replacing the
door. Do not lift the door by the
handle. This can cause the glass
to break or can cause damage to
the door.
To remove the door, open it a
few inches to the special stop
position that will hold the door
open. Grasp firmly on each side
and lift the door straight up and
off the hinges.
NOTE: Be careful not to place hands between the
hinge and the oven door frame
snap back and pinch fingers.
To replace the door, make sure the hinges are in the
special stop position. Position the slots in the bottom
door slowly and evenly over both hinges at the same
time. If hinges snap back against the oven frame, pull
them back out. If the oven door is crooked, push
down on the high corner to straighten it.
TO CLEAN THE DOOR:
Inside of the door:
the self clean cycle, you do not need to clean this by
hand. Any soap left on the liner causes additional
stains when the oven is heated.
scouring pad.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb,
disconnect the electric power for your range at the
main fuse or circuit breaker panel or pull the plug.
before removing or-replacing them. When in use, light
bulbs can become warm encugh to break if touched
with a moist cloth or towel. W-hen cleaning, avoid
touching warm lights with cleaning cloths if the light
cover is removed.
The o~en light (bulb) is
covered with a removable
glass cover which is held
in place with a wire. Remove
the oven door, if desired, to
reach the cover easily.
28
CARE AND CLEANING
(continued)
the could
hinge
as
(on some models)
.
holder
cover
Do not rub or clean the door gasket—the fiberglass
material of the gasket has an extremely low
resistance to abrasion. An intact and well-fitting
oven door gasket is essential for energy-efficient
oven operation and good baking results. If you
notice the gasket becoming worn, frayed or damaged
in any way or if it has become displaced on the door.
you should have it replaced.
NOTE: The gasket is designed with a gap at the
bottom to allow for proper air circulation.
'/
Use soap and water to thoroughly clean the top,
sides and front of the oven door. Rinse well.
You may also use a glass cleaner to clean the glass
on the outside of the door. To avoid water marks on
the inside of the glass door, do not let water drip in
the vent openings.
Spillage of marinades, fruit juices, tomato sauces
and basting materials containing acids may cause
discoloration and should be wiped up immediately.
When surface is cool, clean and rinse.
Do not use oven cleaners, cleansing pov'ders or
harsh abrasives on the outside of the door.
To remove:
Hold your hand under the cover so it doesn't fall
when released. With fingers of the same hand,
firmly push back the wire cover holder. Lift oft
the cover.
DO NOT REMOVE ANY SCREWS.
Replace bulb with 40-watt home appliance bulb.
To replace cover:
Place it into the groove of the light receptacle. Pull
the wire forward to the center of cover until it snaps
in place. When in place, the wire holds the cover
firmly. Be certain the wire is in the depression in the
center of the cover.
o Connect electric power to the range.
Inside Gasket
I