40cm Petrol Wheeled Rotary Lawnmower Original Instructions For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com firstname.lastname@example.org...
IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct Telephone : 01325 300303 Explanation of Symbols on your product...
If not used properly this lawnmower can be dangerous! This lawnmower can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this lawnmower. The operator is responsible for following the warning and safety instructions in this manual and on the lawnmower.
Assembly Instructions Lower Handles 1. Insert the lower handle into the deck as shown in Fig. 2. Push the handle firmly down until it is located se- curely into the deck. 3. Insert the screw into the hole using a pozidrive screw- driver and tighten fully.
1. To fill with oil:- a) Remove oil filter cap. b) Fill to the FULL mark on the dipstick. 2. Use a good quality SAE 30 four stroke oil. 3. Check oil level periodically and after every five hours of operation. 4.
Starting and Stopping Please note:- When starting the engine for the first time, fill with oil and petrol as described above in the Engine Notes section. PUSH LAWNMOWER 1. Connect the spark plug lead. Starting the cold engine Push primer bulb firmly 3 times before starting cold engine. (F1) (Also, if the engine has stopped because it has ran out of fuel, refuel engine and push primer 3 times).
Should you require service under the terms of our guarantee the Service Centre will require proof of purchase. All of the centres listed stock genuine Husqvarna Spare Parts. NOTE: Our Service Repairers act on their own behalf and are not empowered to commit or legally bind Husqvarna UK Ltd.
ENVIRONMENTAL INFORMATION Husqvarna UK Ltd. are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products’ life.