Cruise Control Indicator Light - Subaru Tribeca 2010 Owner's Manual

! To decrease the speed (by control
lever)
Push the control lever downward in the
"SET/COAST" direction and hold it until
the vehicle reaches the desired speed.
Then, release the control lever. The
vehicle speed at that moment will be
memorized and treated as the new set
speed.
When the difference between the actual
vehicle speed and the set speed is less
than 4 mph (6.8 km/h), the set speed can
be lowered 1 mph (1.6 km/h) each time by
pressing the control lever downward in the
"SET/COAST" direction quickly.
! To decrease the speed (by brake
pedal)
1. Depress the brake pedal to release
cruise control temporarily.
2. When the speed decreases to the
desired speed, press the control lever
downward in the "SET/COAST" direction
once. Now the desired speed is set and
the vehicle will keep running at that speed
without depressing the accelerator pedal.
& Cruise control indicator light
The cruise control indicator light illumi-
nates when the ignition switch is turned to
the "ON" position and turns off after
approximately 3 seconds.
The light illuminates when the "CRUISE"
main switch is pressed.
Starting and operating
If you move the cruise control lever while
turning the ignition switch "ON", the cruise
control function is deactivated and the
cruise control indicator light flashes. To
reactivate the cruise control function, turn
the ignition switch back to the "Acc" or
"LOCK" position, and then turn it again to
the "ON" position.
& Cruise control set indicator
light
The cruise control set indicator light
illuminates when the ignition switch is
turned to the "ON" position and turns off
after approximately 3 seconds.
The light illuminates when vehicle speed
has been set.
7-33