Summary of Contents for ULT DW-86L288
- Page 1 ULT Freezer DW-86L288/388/628 DW-86W420 Read this user's manual carefully before using the ULT freezer. Place this manual in a convenient location for future reference.
- Page 2 Technical data .......................15 Packing list ......................15 The actual design, color, and door pattern of your Haier ULT may vary as a result of continuous improvement. This ULT unit should not be used to store live creatures or fresh flowers, as they require special...
-
Page 3: Troubleshooting
In the process of using the unit, you should pay attention to how the unit operates. Should there be changes of the materials stored in the unit, follow the guidelines The Haier ULT is equipped with a microcomputer control, and a below to attempt to correct the situation. If the conditions do not improve, please... - Page 5 The appliance requires 220V/50Hz for 628/388/ A dedicated power socket is required to When cleaning the freezer, use a soft cloth or Unplug the unit before cleaning. 288/310 or 220V/50Hz and 220V/60Hz for 628. operate this unit. A standard three-prong sponge with light soapy water.
- Page 6 Freezer Defrosting, Storage of Unit The unit should be located on a solid surface Defrosting Keep the unit away from direct sunlight or any without any packing materials. When moving heat source. The freezer should only operate 1.During normal usage of the unit, the interior 2.Before the defrost process starts, remove all the unit, never tilt it over 45 degrees nor of the unit accumulates frost.
- Page 7 D.If the set point temperature, the high temperature alarm, and the low temperature alarm are set at the same time, make sure to leave the indicator to “Low Temperature Alarm” position after all adjustments are performed. Leave the panel untouched for 10 seconds. The unit 2.Check all accessories 1.Remove all packing enters the locked mode.
- Page 8 ,especially before Voltage Regulator summer. ULT FREEZER 3.Adjustment of Control Panel When the unit is in the locked mode, all keys are in the locking mode. This is to prevent the unit from mis-operation. To adjust the control, the keys must be unlocked first. The procedure Funtion and operating instructions of the control panel is as follows.