Team.selector - Kagan MegaTimer Instruction Manual

The Team Selector randomly selects a team number from a set
pool—up to a maximum of 99 teams. Each repeated use randomly
selects a new, unused team number to avoid repeated selections of
the same team. After all team numbers have been selected, all team
numbers become available again upon the next use.
To Use the Team Selector
Press the Team Selector button. The selector randomly selects a team num-
ber from the last set pool. Each press of the Team Selector button selects a
new, unused team number from within the set pool until all team numbers
have been selected.
(Note: For random instead of no-repeat random selection, use Random.)
To Set the Team Selector
1. Hold down the Team Selector button until the top display
prompts, "SET T POOL."
2. Use the Up and Down arrows to set the new team pool.
3. Press Team Selector again to accept the new team pool.
(Tip: In the set state, hold down the Start/Stop button to clear the team pool
to 2.)
Pick One Team in the Class to...
• Share team's answer
• Summarize team's ideas
• Share team's list
• Present team's project
• Perform a task
• Go first
Kagan Publishing • (800) 933-2667 • www.KaganOnline.com
Team Selector
MegaTimer™ Instruction Manual
To Use the Student and
Team Selectors Together
Press the Student Selector first. Have
one student on each team with the
selected number stand up. Press the
Team Selector next. The standing
student on that team is selected.
9