AEG LAVATHERM T76280IC User Manual page 18

18 www.aeg.com
Problem
Unsatisfac-
tory drying
results.
The door
does not
close.
Err (Error)
on the dis-
play.
No drum
5)
light
Abnormally
elapsing
time on the
display.
Programme
inactive.
1)
Possible cause
The loading door is opened.
The On/Off button was not
pushed.
The Start/Pause button was not
pushed.
The appliance is in the standby
mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus function was in
minimum mode.
The condenser is clogged.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the inner surface of the
drum.
Too high water hardness.
The filter not locked in the po-
sition.
The laundry is locked between
the door and the seal.
You try to change the pro-
gramme or the function after
the start of the cycle.
The function you try to activate
is not applicable with the selec-
ted programme.
Defective drum light.
The time to end is calculated
on the basis of the volume and
dampness of the laundry.
)
The water container is full.
Remedy
Close the loading door.
Push the On/Off button.
Push the Start/Pause button.
Push the On/Off button.
Do the selection of the applica-
2)
ble programme.
3)
Clean the filter.
Change the Dry Plus function
to the moderate or maximum
mode.
Clean the condenser.
Obey the maximum load vol-
ume.
Clean the airflow grill in the
bottom of the appliance.
Clean the inner surface of the
drum.
Set applicable water hard-
4)
ness .
Put the filter in the correct posi-
tion.
Put the load correctly in the
drum.
Turn the tumble dryer off and
on. Make the new selection.
Turn the tumble dryer off and
on. Make the new selection.
Contact the service centre to
replace the drum light.
The automatic procedure —
this is not the appliance mal-
function.
Drain the water container
push the Start/Pause button.
3)
3)
,