Hyundai Elantra Owner's Manual page 110

HD HMA 4~59.qxd 5/29/2006 5:46 PM
Features of your vehicle
WARNING
• When programming
HomeLink® Wireless
System, you may be operating a
garage door or gate operator.
Make sure that people and objects
are out of the way of the moving
door or gate to prevent potential
harm or damage.
• Do not use HomeLink with any
garage door opener that lacks the
safety stop and reverse feature as
required by federal safety stan-
dards. (This includes any garage
door opener model manufactured
before April 1, 1982.) A garage
door opener which cannot detect
an object, signaling the door to
stop and reverse, does not meet
current federal safety standards.
Using a garage door opener with-
out these features increases risk
of serious injury or death. For
more information, call 1-800-355-
3515 or on the internet at
www.homelink.com.
4 32
Page 32
Retain the original transmitter for future
programming procedures (i.e., new vehi-
cle purchase). It is also suggested that
the
upon the sale of the vehicle, the pro-
Control
grammed HomeLink buttons be erased
for security purposes (follow step 1 in the
"Programming" portion of this text).
Programming
Your vehicle may require the ignition
switch to be turned to the ACC position
for programming and/or operation of
HomeLink. It is also recommended that a
new battery be replaced in the hand-held
transmitter of the device being pro-
grammed to HomeLink for quicker train-
ing and accurate transmission of the
radio-frequency.
Follow these steps to train your
HomeLink mirror:
Flashing
OVQ036306N
1. When programming the buttons for the
first time, press and hold the left and
center buttons ( , ) simultane-
ously until the indicator light begins to
flash after approximately 20 seconds.
(This procedure erases the factory-set
default codes. Do not perform this step
to program additional hand-held trans-
mitters.)