Technical Specifications. Noise And Vibration Measurement - Husqvarna FS 800 E Operator's Manual

Husqvarna cordless saw user manual
Table of Contents

Advertisement

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
FAULT
Blade turns wrong way.
Drive belt is slipping.
Motor cuts out.
No cooling water.
Blade gets jammed.
Motor does not start.
NOTE! Do not start the machine before rectifying the cause of the fault.
9. Technical specifications
The table below gives the technical specifications for the
FS800 E/EM floor saw. It is extremely important that you
check these before:
- Choosing a floor saw.
- Choosing and fitting a diamond blade.
- Connecting to the mains supply.
- Choosing a power cable.
- Choosing the cutting depth.
- Transporting the machine.
If you are unsure about the meaning of the technical specifica-
tions or ordering spare parts, please contact your supplier
CAUSE
Phases from power cable are inverted.
Belt is too slack.
Drive belt is worn.
Drive belt is oily.
Cutting depth too large.
Cutting speed too high.
Diamond segments are worn.
Electrical fault.
Nozzles are blocked.
Water pressure low.
Blade is worn.
Cut closing up.
Electrical fault.
Emergency stop activated.
REMEDY
Change polarity using phase inverter.
Adjust belt tension.
Replace the drive belt.
Clean the drive belt.
Reduce cutting depth.
Advance more slowly.
Replace diamond blade.
Contact a qualified electrician.
Clean nozzles.
Replace blade.
Cut smaller sections, or
support from below using props or a jack.
Contact your electrician.
Determine cause. When fault is
fixed, pull up emergency stop.
FS800 E/EM ART. NOS. 50020 AND 50030
Motor rating
Voltage and type of supply
Power cable
Polarity
Phase inverter
Drive shaft speed
Max. peripheral speed.
Max. diamond blade diameter
Parking brake
Base plate
Chain drive
Max. Cutting depth
Length approx.
Width approx.
Height approx.
Weight (excl. blade) approx.
Noise
Noise
Vibration
10
kw
7.5
V/phase/Hz
400/3/50 or
220/3/50
REVE
5x2.5
Europa plug
16 Amp.
in socket
rpm
1150
m/s
63
mm
800
yes
optional
accessory
optional
accessory
mm
320
mm
1500
mm
780
mm
1120
kg
220
noise power
<101.7
Lw rel. pw
according to ISO
744 dB(A)
noise pressure
<84.8
Lp rel. 0µPa at
ear during
operation B(A)
according to.
0.8 m/s2 (H/A)
ISO 7505

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fs 800 em

Table of Contents