Table of Contents
Advertisement
CHANGING THE SYSTEM PIN
The system PIN is used for registering, deleting handsets, and protecting the access rights to some
of the other menus. The pre-set system PIN is 0000. You can personalize the PIN for greater
security.
1. Press
SYSTEM
2. Select
3. Enter the system PIN. Press
4. Enter the new system PIN. Press
5. Enter the new system PIN again for verification.
6. Press
NOTE:
Forgotten PIN. Write down your PIN and save it for future use. If you
have forgotten the PIN, call your manufacturer for assistance.
SETTING LOW RADIATION MODE
You can set your phone to emit lower radiation power when the phone is inactive. Your phone will
return to normal power when you are using it again.
1. Press
SYSTEM
2. Select
ON
3. Select
confirm. The new setting is saved.
RESETTING TO DEFAULT SETTINGS
The default settings are the original factory settings of your phone. You can reset your phone
settings to factory default.
1. Press
SYSTEM
2. Select
3. Enter the system PIN. Press
request.
4. Press
NOTE:
After reset, your handset's power switches off. It will switch back on in a
few seconds after updating all the settings.
To find out what settings are being reset, see Default (pre-programmed) settings on page 24.
.
CHANGE PIN
. The new setting is saved.
.
LOW RF POWER
to activate low radiation mode or
.
RESET
. Press
to confirm. All settings have reset.
- 23 -
. Press
.
to confirm. Use
.
. Press
.
OFF
to deactivate. Press
.
to confirm. The handset displays a confirmation
The System
to make correction.
to
Advertisement
Table of Contents
