Table of Contents
Advertisement
The System
TIP:
Use
REGISTERING YOUR HANDSET WITH ADDITIONAL BASE
This section shows you how to register your handset to additional base unit(s). If your handset
UNREGISTERED
displays
1. Press
2. Press
SYSTEM REGISTER
3. Select
4. Enter the system PIN (Pre-set: 0000). Use
5. Press 1, 2, 3, or 4 to select the base number you want. This base number will be
assigned to the base unit you are about to register to. Your handset starts searching
for the base.
Registration shall be completed within 30 seconds.
NOTE:
Each handset can register up to 4 base units. After registering to 4 base
units, your handset registration memory is full. If you attempt to register to
additional base units, registration will not be successful.
SELECTING A BASE UNIT
You can switch your handset between different registered base units. You can program the
handset to automatically connect to the closest base unit or only connect to a fixed base unit you
have specified.
1. Press
SYSTEM
2. Select
3. Select the base unit you want or select
automatically connect to the closest base unit.
4. Press
DELETING A HANDSET
Use one handset to delete (de-register) another handset that shares the same base unit.
1. Press
SYSTEM
2. Select
3. Select the handset (number) you want to delete. Press
TIP:
Handset Number. The handset number displays beside the handset name
during standby.
4. Enter the system PIN. Use
5. Press
or
, refer to Registering your handset on page 9.
on the base unit for 4 seconds.
on the handset.
Press
.
SELECT BASE
. The new setting is saved.
.
DELETE HS
. The handset is deleted.
to navigate the menus.
.
. Press
.
AUTO
if you want your handset to
. Press
.
to make correction.
22
to make correction.
.
Advertisement
Table of Contents
