Installation Instructions; Use And Maintenance - Mastercook WK-Cristal Use And Care Manual

To transform the hood from a ducting version into a filtering version, ask your dealer for
the charcoal filters and follow the installation instructions.
? FILTERING VERSION
Install the hood and the two flues as described in the paragraph for installation of the
hood in ducting version. To assemble the charcoal filters refer to the instructions below.
• It is recommended to operate the appliance prior to cooking.
It is recommended to leave the appliance in operation for 15 minutes after cooking is
terminated in order to completely eliminate cooking vapors and odours.
The proper function of the cooker hood is conditioned by the regularity of the maintenance
operations, in particular, the active carbon filter.
• The anti-grease filters capture the grease particles suspended in the air, and are
therefore subject to clogging according to the frequency of the use of the appliance.
In order to prevent fire hazard, it is recommendable to clean the filter at a maximum of 2
months by carrying out the following instructions:
- Remove the filters from the cooker hood and wash them in a solution of water and
neutral liquid detergent, leaving to soak.
- Rinse thoroughly with warm water and leave to dry.
- The filters may also be washed in the dishwasher.
The aluminum panels may alter in color after several washes. This is not cause for
customer complaint nor replacement of panels.
• The active carbon filters purify the air that is replaced in the environment. The filters are
not washable nor reuseable and must be replaced at maximum every four months. The
saturation of the active carbon filter depends on the frequency of use of the appliance, by
the type of cooking and the regularity of cleaning the anti-grease filters. (Fig 6) To remove
the charcoal filters place on hand on one filter at a time and turn it in directions indicated by
the A arrows. The charcoal filter can now be removed. Always ensure to replace both filters
at the same time.
In order to install new charcoal filters, place each one on both sides of the motor and turn
them in directions indicated by the B arrows (Fig 6).
• Clean the fan and other surfaces of the cooker hood regularly using a cloth moistened
with denatured alcohol or non abrasive liquid detergent.
• The illumination installation is designed for use during cooking and not for prolonged
general illumination of the environment. Prolonged use of the illumination installation
notably reduces the duration of the bulb.
Use a one-edged screwdriver or any other appropriate tool to lift and remove the
overhead light fixture. Replace the damaged lamp. Use only halogen lamps as the original

INSTALLATION INSTRUCTIONS

USE AND MAINTENANCE

20