Advertisement
Information to User
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference
that may cause undesired operation.
Alteration or modifications carried out without
appropriate authorization may invalidate
the user's right to operate the equipment.
Note
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
If you want to dispose this product, do
not mix it with general household waste.
There is a separate collection system for
used electronic products in accordance
with legislation that requires proper
treatment, recovery and recycling.
Private households in the member states of the EU,
in Switzerland and Norway may return their used
electronic products free of charge to designated
collection facilities or to a retailer (if you purchase a
similar new one). For countries not mentioned above,
please contact your local authorities for the correct
method of disposal.
By doing so you will ensure that your disposed product
undergoes the necessary treatment, recovery and
recycling and thus prevent potential negative effects on
the environment and human health.
WARNING:
Handling the cord on this product or cords associated
with accessories sold with the product may expose you
to chemicals listed on proposition 65 known to the State
of California and other governmental entities to cause
cancer and birth defect or other reproductive harm.
Wash hands after handling.
Precautions
IMPORTANT SAFEGUARDS
Please read all of these instructions regarding this
product and retain them for future reference.
1 Do not install this product where it may (i)
obstruct the driver's vision, (ii) impair the
performance of any of the vehicle's operating
systems or safety features, including air bags,
hazard lamp buttons or (iii) impair the driver's
ability to safely operate the vehicle.
2 Do not operate this product if doing so in any
way will divert your attention from the safe
operation of your vehicle. Always observe safe
driving rules and follow all existing traffic
regulations. If you experience difficulty in
operating the system or reading the display,
park your vehicle in a safe location and make
necessary adjustments.
3 Please remember to wear your seat belt at
all times while operating your vehicle. If you
are ever in an accident, your injuries can be
considerably more severe if your seat belt is
not properly buckled.
4 Never use headphones while driving.
5 To promote safety, certain functions are
disabled unless the parking brake is on, and
the vehicle is not in motion.
6 Never set the volume of your display so high
that you cannot hear outside traffic and
emergency vehicles.
WARNING
Do not attempt to install or service this product by
yourself. Installation or servicing of this product
by persons without training and experience in
electronic equipment and automotive accessories
may be dangerous and could expose you to the
risk of electric shock or other hazards.
To avoid battery exhaustion
Keep the vehicle engine running when using this unit
to avoid draining the battery power.
Important
• This unit can not be installed in a vehicle that does
not have an ACC (accessory) position on the ignition
switch.
ACC position
No ACC position
• Use of this unit in conditions other than the following
could result in fire or malfunction.
— Vehicles with a 12-volt battery and negative
grounding.
• To prevent a short-circuit, overheating or malfunction,
be sure to follow the directions below.
— Disconnect the negative terminal of the battery
before installation.
— Secure the wiring with cable clamps or adhesive
tape. Wrap adhesive tape around wiring that
comes into contact with metal parts to protect the
wiring.
— Place all cables away from moving parts, such as
the shift lever and seat rails.
— Place all cables away from hot places, such as
near the heater outlet.
— Do not connect the yellow cable to the battery
by passing it through the hole to the engine
compartment.
— Cover any disconnected cable connectors with
insulating tape.
— Do not shorten any cables.
— Never cut the insulation of the power cable of
this unit in order to share the power with other
devices. The current capacity of the cable is
limited.
— Use a fuse of the rating prescribed.
Notes
• Check all connections and systems before final
installation.
• Do not use unauthorized parts as this may cause
malfunctions.
en
• Consult your dealer if installation requires drilling of
holes or other modifications to the vehicle.
• Install the unit where it will not get in the driver's
way and will not injure passengers if there is a sudden
stop.
• When mounting this unit, make sure none of the leads
are trapped between this unit and the surrounding
metalwork or fittings.
• Do not mount this unit near heater outlets where it
would be affected by heat, or near the doors where
rainwater might splash onto it.
• Before drilling any mounting holes, always check
behind where you want to drill the holes. Do not drill
into the gas line, brake line, electrical wiring or other
important parts.
• If this unit is installed in the passenger compartment,
anchor it securely so it does not break free while the
vehicle is moving, causing injury or an accident.
• If this unit is installed under the front seat, make sure
it does not obstruct seat movement. Route all leads
and cords carefully around the sliding mechanism so
they do are not caught or pinched in the mechanism
and cause a short-circuit.
Before you start
Thank you for purchasing this PIONEER
product
To ensure proper use, please read through this manual
before using this product. Please keep the manual in
a safe and accessible place for future reference.
About this unit
This unit is a smartphone link adaptor for the Pioneer
DVD RDS AV Receiver.
CAUTION
• Do not allow this unit to come into contact with
liquids. Electrical shock could result.
Also, damage to this unit, smoke, and overheating
could result from contact with liquids.
• Keep this manual handy for future reference.
• Always keep the volume low enough to hear outside
sounds.
• Avoid exposure to moisture.
• Should this unit fail to work properly, please contact
your dealer or nearest authorized PIONEER Service
Station.
Note
Refer to the Pioneer head unit owner's manual for
operating instructions for the Pioneer head unit.
Advertisement
