Operating Features - Kenwood TKR-750 Service Manual

TKR-750
2. Two 7-segment LED displays
• Channel display (1~16) : While operating normally in user
mode.
• When the displayed channel is contained in scan se-
quence, the right side decimal point is displayed.
• When the displayed channel is the priority channel, the
left side decimal point is displayed.
• "PC" is displayed while in PC mode.
• "PG" is displayed while in firmware programming mode.
2 decimal points displayed = 115,200bps
1 decimal point displayed = 57,600bps
No decimal = 38,400bps
• "E1" is displayed when FPU data is not written.
4

OPERATING FEATURES

• "E2" is displayed when the channel data is not written.
• "E3" is displayed when PLL is unlocked.
• "E4" is displayed when PTT is attempted on a channel
• "SC" is displayed while in scan mode.
Receiver PLL unlocked = flashing BUSY LED.
Transmitter PLL unlocked = flashing TX LED.
number that has no frequency data programmed.