Operating Features - Kenwood NXR-810 Service Manual

NXR-810
1. Two 7-segment LED Displays
• Channel display (1~30): While operating normally in user
mode.
• When the displayed channel is contained in scan se-
quence, the right side decimal point is displayed.
• When the displayed channel is the priority channel, the
left side decimal point is displayed.
• "PC" is displayed while in PC mode.
• "PG" is displayed while in fi rmware programming mode.
2 decimal points displayed = 115,200 bps
1 decimal point displayed = 57,600 bps
No decimal = 38,400 bps
• "E1" is displayed when FPU data is not written.
• "E2" is displayed when the channel data is not written.
8

OPERATING FEATURES

• "E3" is displayed when PLL is unlocked.
• "E4" is displayed when PTT is attempted on a channel
• "SC" is displayed while in scan mode.
• "E5" is ESN blank error.
• "E.6." is MCU internal RAM error.
• "E6." is DSP RAM error.
• "E6" is MCU External RAM error.
Receiver PLL unlocked = BUSY LED blinks.
Transmitter PLL unlocked = TX LED blinks.
number that has no TX frequency data programmed.