Advertisement
Quick Links
Advertisement
Related Manuals for Digimax 210
Summary of Contents for Digimax 210
- Page 1 Digimax 210 Programmable Thermostat User Guide...
-
Page 2: Operation
The RF DigiMax 210 thermostat does not need any extra wiring and works within 30 meters range around the receiver RF-Max. The DigiMax 210 is equiped of a secured RF code which the RF Max will learn during the installation process. -
Page 3: Installation
30 meters Please read all installation instructions before proceeding. The RF DigiMax 210 works with batteries. It does not need any wire. If you wish it to replace an old cable thermostat, isolate and secure the old wires, which are useless now. Do not forget to cut the power when you take off the old thermo- stat. - Page 4 IV Position The ideal position to locate the DigiMax 210 Digital Room Thermostat is about 1.5m above floor level, accessible, free from extremes of temperature and draughts. Do not mount on an outside wall, above a radiator or where it may be sub- jected to direct sunlight.
-
Page 5: Battery Replacement
2 Locate and identify the two option Links 1 and 2. Use a pair of small wire cutters to cut the appropriate links to give the required configuration. 3 Cutting Link 1 will give a minimum temperature set point of 16°C (factory default is 5°C). Cut link 2 to display cooling symbol instead of heating symbol. - Page 6 RF link between the Thermostat RF DigiMax 210 and the RF-Max a) Commissioning The RF DigiMax 210 is required to be matched with the RF- Max receiver. This is to ensure only the correct thermostat is controlling your ambient temperature. The thermostat sends a signal which is a unique code (1 of 65000), which only the matched RF-Max receiver is capable of understanding.
- Page 7 1. To install thermostat with the RF receiver press and hold the OK and COPY keys together in Auto mode for 3 seconds. The DigiMax 210 will then transmit its unique digital code every 10 seconds for the next 5 minutes. The...
- Page 8 5. The R-Max Receiver will now only respond to radio sig- nals with the installed code i.e. from the DigiMax 210 Ther- mostat just installed. Even if the power is removed from the Receiver it will not forget the installed code.
- Page 9 utes the Red LED will flash for 3 seconds. If the RF-Max does not receive regular RF signals the Red LED will come full on indicating that a fault condition has occured and the heating system will be switched off. Note : If more than one “Thermostat RF- RF Receiver”...
- Page 10 4. Trouble shooting If the heater does not operate when the thermostat is asking for warm, check the battery indicator and changes the battery units if necessaru. If the indicator has vanished, remplace the piles for you have probably missed the signal indicating weak battery.
- Page 11 Extending the SC9000 security console with a Digimax 210 thermostat. The HF DigiMax 210 thermostat does not require extra wiring and has a radius of 30 m. The appliance is equipped with a protected HF code. This code is registered with the SC9000 during installation. This code ensures that the SC9000 will only respond to messages sent by your DigiMax 210.
- Page 12 Extending the SC9000 security console with a Digimax 210 thermostat. If the console has not received any more messages from the thermostat, the LCD display will read [PROBLEM ZONE X] Programming the “differential temperature” on the console The thermostat needs to be registered with the SC9000 to be able to view the Setback settings in the OPTIONS menu (7).
Need help?
Do you have a question about the 210 and is the answer not in the manual?
Questions and answers