Martin Inground 200 Single Color User Manual page 7

Guarding against electric shock
• Isolate the fixture from AC power before removing or installing the lamp,
fuses, or any part.
• Always ground (earth) the fixture electrically.
• Use only a source of AC power that complies with local building and
electrical codes and has both overload and ground-fault protection.
• Refer any service not described in this user manual to a Martin service
technician.
Lamp safety and eye protection
• Never operate the fixture with missing or damaged lenses and/or covers.
• Do not stare directly into the light. Never look at an exposed lamp while it
is lit.
• Wear safety glasses during beam adjustment.
• Use only approved lamp types (see "Source" on page 65).
• Replace the lamp if it becomes defective or worn out. The average life of
the Philips CDM-SA/T 150W/942 lamp supplied with the Inground 200
CMY is 9000 hours. If one of the approved alternative lamp types listed
under "Source" on page 65 is fitted, see the lamp supplier's
documentation.
Guarding against burns and fire
• Allow the fixture to cool for at least 15 minutes after use before opening it
for service or adjustment.
• Wear heat-resistant safety gloves during beam adjustment.
• Never attempt to bypass the thermostatic switch or fuses. Always replace
defective fuses with ones of the specified type and rating.
• Keep all combustible materials (for example fabric, wood, paper) at least 1
meter (39 inches) away from the fixture. Keep flammable materials well
away from the fixture.
• Ensure that litter, dry leaves or other combustible materials cannot
accumulate on or near the fixture.
• Prevent vehicles from being parked over or near fixtures – including unlit
fixtures that may later be switched on.
• Do not illuminate surfaces within 0.5 meters (20 inches) of the fixture.
• Install the fixture outdoors or in a well ventilated area.
• The exterior of the fixture can become very hot, up to 80° C (176° F)
during normal operation. Ensure all local safety regulations and legal
requirements are observed, and take appropriate measures to warn or
restrict access.
• Do not modify the fixture or install other than genuine Martin parts.
• Never place filters or other materials over the front glass.
Safety information 7