Installation And Operation; Unpacking; Installation - Motorola GX2-PSAC10D-R Installation And Operation Manual

S e c t i o n 3
I n s t a l l a t i o n a n d O p e r a t i o n
This section provides instructions to install the GX2-PSAC10D-R power supply in the GX2-HSG*
and verify its operation.
U n p a c k i n g
Unpack the GX2-PSAC10D-R and inspect it for damage. If damage is visible, set it aside in the
original packing material and contact the Motorola Customer Service Department for further
instructions.
Record the model number, serial number, and related information for future reference.
I n s t a l l a t i o n
To operate, the GX2-HSG* must be equipped with a GX2-PSAC10D-R or GX2-PSDC10D-R power
supply. To install the GX2-PSAC10D-R power supply:
1
Rotate the power supply so that the cooling fans face you and the external power connection is
on the left.
2
Position the power supply into the left- or right-side power supply compartment on the rear of
the GX2-HSG* as illustrated in Figure 3-1:
F i g u r e 3 - 1
G X 2 - P S AC 1 0 D - R
3
Insert the power supply completely into the chassis ensuring that connection is made with the
backplane connectors.
4
Secure the power supply by tightening the two captive thumbscrews into the GX2-HSG*.
5
Plug the IEC connector end of the ac power cord into the rear of the GX2-PSAC10D-R.
G X 2 - P S A C 1 0 D - R I n s t a l l a t i o n a n d O p e r a t i o n M a n u a l