Transmission Messages - GMC Yukon 2011 Owner's Manual

5-46 Instruments and Controls
Have the tire pressures checked
and set to those shown on the Tire
Loading Information label. See Tires
on page 10 48, Vehicle Load Limits
on page 9 23, and Tire Pressure on
page 10 56. The DIC also shows
the tire pressure values. See DIC
Operation and Displays (With DIC
Buttons) earlier in this section.

Transmission Messages

SERVICE 4 WHEEL DRIVE
This message displays if a problem
occurs with the four-wheel-drive
system. If this message appears,
stop as soon as possible and turn
off the vehicle. Make sure the key is
in the LOCK/OFF position for at
least one minute and then restart
the vehicle and check for the
message on the DIC display. If
the message is still displayed or
appears again when you begin
driving, the four-wheel-drive system
needs service. See your dealer.
TRANSMISSION HOT IDLE
ENGINE
Notice: If you drive the vehicle
while the transmission fluid is
overheating and the transmission
temperature warning is displayed
on the instrument panel cluster
and/or DIC, you can damage the
transmission. This could lead to
costly repairs that would not be
covered by the warranty. Do not
drive the vehicle with overheated
transmission fluid or while the
transmission temperature
warning is displayed.
This message displays along with a
sound if the transmission fluid in the
vehicle gets hot. Driving with the
transmission fluid temperature high
can cause damage to the vehicle.
Stop the vehicle and let it idle to
allow the transmission to cool. This
message clears and the chime
stops when the fluid temperature
reaches a safe level.
Vehicle Reminder
Messages
CHECK TRAILER WIRING
On vehicles with the Integrated
Trailer Brake Control (ITBC) system,
this message may display and a
chime may sound when one of the
following conditions exists:
A trailer with electric brakes
becomes disconnected from the
vehicle.
If the disconnect occurs while
the vehicle is stopped, this
message clears itself after a
short time.
If the disconnect occurs while
the vehicle is moving, this
message stays on until the
ignition is turned off.
There is a short in the wiring to
the electric trailer brakes.
When this message displays, power
is no longer available to the trailer
brakes.