Advertisement
In order to obtain the best results and to maintain your Rinnai Built-In Hob in the best condition, please
read the instruction carefully.
Components and Features
Components and parts names
Pan Support
M Burner Head
M Burner Body
M Burner Cover
Knob
Casing
Safety Sensor
Electrode
Gas Inlet
(For Singapore model only)
Pan Support
Burner Cap
H Burner Head
H Burner Body
H Burner Cover
Tempered Glass
Stainless Top Plate
Fig. 1
- 1 -
Maintenance
•
Wipe the tempered glass with a soft damp cloth and mild detergent.
•
Wash the Pan Support and Burner Covers in warm water and detergent.
Trouble Shooting Manual for Rinnai RB-3SS Built-in Hob
FAULT
CAUSE
1. No Ignition
Spark electrode is wet, especially in
high humidity season
2. Flame cannot be
Incorrect turning of gas control
held
knob.
3.1 Gas Regulator has been
3. No main flame
turned off
3.2 Burner cap is blocked by
aluminum foil.
4. Yellow flame
Accumulated grease and dirt
on the burner head.
Incorrect location of the burner head.
5. Unstable flame
Attention: when installing the casing
•
Adjust screw position as bench cut out size.
•
Confirm that six screws are firmly secured into the casing.
REMEDY
Dry the electrode with clean tissue
or dry cloth.
Push and turn the gas control knob
anti-clockwise until a 'click' sound
is heard. Hold for a few seconds until
flame is ignited.
Open gas regulator completely
Remove aluminum foil.
Wash the burner head in warm water
with detergent. Leave it to dry; then
place it back in the correct position.
Refit the burner head into the burner
body
- 6 -
Advertisement
