Operation; Maintenance; Cleaning The Tool - Makita MU01 Instruction Manual

1
2
010903
At this time, make sure that the locking lever fits in the
groove in the undercover.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades does not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.

OPERATION

WARNING:
Keep hands away from blades.
•
CAUTION:
Smear the blade before and once per hour during
•
operation using machine oil or similars.
Avoid operating the tool under the scorching
•
sunlight as much as practicable. When operating
the tool, be careful of your physical conditions.
010874
Turn the tool on after adjusting the shearing height and
hold it so that the foot of the tool rest on the ground. Then
gently move the tool forward into the area to be cut.
010875
1. Groove in the
undercover
2. Locking lever
11
When trimming around curb, fence or trees, move the
tool along them. Be careful for the blade not to contact
them.
010876
When trimming sprouts or foliage of a small tree, remove
the base frame from the tool and cut little by little.
Shear big branches to your desired height beforehand
using branch scissors before using this tool.
CAUTION:
When trimming twigs and foliage, do not attempt to
•
trim too much at a time. Proceed gently. Also do
not attempt to cut thick branches.
Do not let the shear blades contact the grounds
•
during operation. The blades will be dulled,
causing poor performance.
Do not trim wet grass or foliage of small trees
•

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.

Cleaning the tool

Clean out the tool by wiping off dust with a dry or
soap-dipped rag.
CAUTION:
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.