Subwoofer Controls - Teufel System 5 Technical Specifications And Operating Manual

Subwoofer controls

Technical Specifications and Operating Manual



 Line In
Connect the mono RCA cable here,
Signal arrives from Sub Out of receiver.
 Line Out
If you do not want to use a Y-splitter, you can
connect the second subwoofer here.
 Automatic starting
When set to "On", the subwoofer will remain per-
manently on. With the "Auto" setting, the subwoof-
er will switch on automatically when it receives an
audio signal. But after approx. 20 minutes without
receiving an audio signal, it will switch off.
 Volume
Use the "Volume" controller to set the volume of
the subwoofer. We recommend setting the con-
troller to the position marked "THX" .
 Phase
This switch determines the phase relationship be-
tween the subwoofer and the front/centre speak-
ers. If the subwoofer is positioned as shown on
page 6, set the phase to 0°. Otherwise, set it to 180°.





 Voltage selector
This switch adapts the internal amplifier to the
local mains voltage. NEVER change this from the
standard local voltage. In Europe, the correct set-
ting is 220 - 240 V.
 Mains power connector
Connect the included mains power cable that
complies with your local mains power require-
ments.
 Fuse
The mains power fuse is located here. Using a
suitable screwdriver, replace this fuse with a suit-
able one (see figure on page 12). Only replace the
fuse when the subwoofer is completely discon-
nected from the mains power supply! Failure
to do so can be fatal!
 Power
In the OFF setting, the subwoofer is switched off;
ON means that it is switched on.

Symbols
The lightning symbol with
arrowhead inside an equilateral
triangle informs the user about
the danger of non-isolated
electrical voltage within the
enclosure with the inherent risk
of electrical shock.
The exclamation mark within
an equilateral triangle, as can
be seen on the back of the unit,
indicates that there are impor-
tant operating and maintenance
instructions for the user to read.
This product complies with the
following EU directives:
2004/108/EC and 2006/95/EC.
The "waste bin" symbol printed
on the type plates and amplifier
labels of our products indicates
that Lautsprecher Teufel will
ensure the proper disposal of
its speakers and subwoofers in
accordance with
Germany's Electrical and
Electronic Equipment Act.
This product complies with DIN
EN 61140 (VDE 0140-1) and IEC
60417 standards for protection
class II. It only requires a two-pin
round plug (included) and not
an earthed plug. The plug has
a reinforced or double-shielded
casing to prevent
electrical shock.
Attention:
The separating equipment of
this equipment is the mains
plug, this separating equipment
must be usable without
difficulties.
· System 5 11